26:th-Oct-2016, 13:54:59
(26:th-Oct-2016, 07:52:49)Rusty2009 Wrote:(25:th-Oct-2016, 21:13:00)aurega Wrote: Hello,
I bought the CAN bus LEDS http://www.dobry-obchod.cz/produkt/95243...vouvlakno/
but ofc there is error on the dash-board. Only solution which I found is to add resistors. I don't want to drill the hole into the headlight back.
Is it possible to add resistors into the fuse box ? or any other place on the way to CANbus check part?
Sorry for my English... I'm from Czech republic.
Thanks,
Jan
No canbus bulbs work without errors on the J DRL's.
You could try tapping a resistor onto Grey/Dark-Blue wire coming out pin 9 on the headlight plug.
Your English is very good by the way.
Hello,
many thx for reply !!! do you have any photo of this plug? And you mean to add this resistor on both? gray one and blue one?
Thanks,
Jan