Welcome back to the VXOC FORUM.
Sorry for our lack of support over the last year but MYBB is back and so are we.
Let's get the forum buzzing again... (March 25, 2022)x
Not long ago i updated my NAVI 600 to 2019 maps, all appeared fine for weeks. Then i had to pop the battery out as it went flat in all this CV business, could not charge in the car as i have to park a way away.
Now im all back in and running, i have noticed i have no sat nav voice, everything else appears fine.
Ive tried a factory reset, and even pulling the fuse and restarting, and nothing.
I have been doing some hunting around for a HID kit for my Astra GTC. Seems like most the information is around on the forum in various threads over the years but nothing that makes it 100% clear (at least to me).
Am I right in saying the following?
1. Astra GTC have the correct headlight units as standard (projectors) to allow legal installation of HID's?
2. You should get the 35w HID kit otherwise there may be MOT issues?
3. The bulbs you need are HIR2 (9012) and NOT H7's.
4. Installation requires removal of the bumper / atleast removal of the headlights?
And finally a couple of questions I am not 100% sure on?
5. Other than kits from HID Direct (who seem totally out of stock), what kits have been tried and tested on Astra GTC's to work faultlessly and not cause Canbus errors?
6. Ever heard of the stealth kit? Stealth Kit (Autobulbs direct)
7. What colour output is most common / not likely to get me flashed at every 5 seconds?
Hello all, i retrofitted full leather interior on my 2012 insignia, easy enough, but now the electrics!! got the buttons for it on the dash (retrofitted as well) any ideas on the electric side how to make them work (the heated system, as the rest works).
got the receiver for the plugs for the seats of the donor car as well.
many thanks
My roof rails look pretty bad as you can see below. Any ideas on how to remove them without braking any clips underneath in order to spray paint them? Where should I start prying?
So, my Astra A16 LET 1.6 Turbo recently sprung a leak as the thermostat housing had split.
Replaced the thermostat and housing and the 2 temperature sensors (one in the housing and 1 on the radiator), which fixed the leak. However, the fan is still constantly on maximum all the time, coolant level low message appearing (I think the radiator is empty as the reservoir is filled up and doesn’t drop), and the coolant temp won’t get over 75C using an OBD reader.
No codes are present with the OBD reader and the heater vents are producing hot air.
Also, Since fitting the thermostat, the fuel gauge is stuck on empty even though it has half a tank in. This was working prior to having the Thermostat and sensors replaced. I assume this is related? It was working prior to this with no issues.
Hi, we've got a problem with my daughters J (1.6 petrol)
started it today and the central info display between the speedo and rev counter doesn't light up
it looked like it trying to say the normal warnings, change oil, put foot on clutch etc all barely visible as not lit up in red