14:th-Jan-2017, 13:21:21
(This post was last modified: 24:th-Jan-2017, 15:36:22 by mart.
Edit Reason: Fix image
)
I found a better place to tap into the reverse light positive feed. You don't need to tap into right by the reverse light and take all the boot trim off and feed wire through cable flexi hose.
Instead open the compartment on the left of the boot by the bot light and there are loads of wires and a connection box in there (see photo).
You will see a load of wires that come down from the rear pillar and it is taped into a bundle of wires (green and white wire). To make sure it is the correct one I put a pin into the wire and put a voltmeter on to check I got 12volts when in reverse
This will save loads of time, no need to take boot trim off, extend parking sensor live wire etc.
Instead open the compartment on the left of the boot by the bot light and there are loads of wires and a connection box in there (see photo).
You will see a load of wires that come down from the rear pillar and it is taped into a bundle of wires (green and white wire). To make sure it is the correct one I put a pin into the wire and put a voltmeter on to check I got 12volts when in reverse
This will save loads of time, no need to take boot trim off, extend parking sensor live wire etc.