How to change fuel filter (diesel cars)

[Rusty2009]

A tow start won't work as you need the clutch in to start the car.

Some info from the Haynes.

Fuel system- priming & bleeding
1. After disconnecting part of the fuel supply system or running out of fuel, it is necessary to prime the fuel system and bleed off any air which may have entered the system components, as follows.

2. Prime the system by switching on the ignition three times for approximately 15 seconds each time.
Operate the starter for a maximum of 30 seconds. If the engine does not start within this time, wait 5 seconds & repeat the procedure.

3. When the engine starts, run it at a fast idle speed for a minute or so to purge any trapped air from the fuel lines. After this time the engine should idle smoothly at a constant speed.

4. If the engine idles roughly, then there is still some air trapped in the the fuel system. Increase the engine speed again for another minute or so then allow it to idle. Repeat this procedure as necessary until the engine is idling smoothly.

If that fails to work grab some easy start and spray through the air intake well turning her over (Had to do this with my veccy).