Simple Retro Fit Way for Xenon

[Rusty2009]

Hello,

Thanks for your all returns....

I see aftermarket is the way to go.. I wish I could find one look exactly orginal (honestly I was looking for the chrome strip in side the headlight :P)

In any case I did some other research and if I understand correctly on orginal xenon high beams are corner lights and projectors work as both high and low? So to tell projector to light the high beam a "signal" needed( That is the part VCI is needed. )... I wonder if this signal can be replicated with a arduino...

The VCI adds all the software and calibration files to the BCM for the AFL system.

Yes you are correct about the dipped and main beam are run off one bulb iirc the mian beam is done via the Canbus network.
Corner lights replace high beam.

It may well work that you can just change the wire of the halogen lamp (as it runs at a higher current) and just keep main beam where the corner lights are.

This may not work and may even throw up errors if you have factory LED sidelights / DRL then you shouldn't get an error for that part.