How-to Extra Boot light.
Ok so first of all you need to feel along the top of the side trim, you will fell there is plastic behind it but as you move along you will feel there is a bit you can push in.
Once you found that area you can start to cut (DO NOT CUT IT ALL WAY) do a small bit to begin with and then slowly make the hole bigger as you go just use try the lamp as you go.
Then make a loom up and feed it through the hole down and down into the hidey hole.
Next remove the rear boot trim, To do this pull the rubber off and then pull the bottom of the trim in towards the front of the car, then using a trim tool lever the top off.
Then feed the loom behind the side trim and work your way along (Sorry not many pics here as some bits you can't get pics of).
Again at the other end feed it up behind the side trim and then feed it to the light (If open the hidey hole and feel the factory loom that will help you with routing this one.)
When wiring up connect you positive to the green and Negative to the Black, then solder and heat-shrink or solder and wrap in Elec tape.
Pop your lights back in and hey pesto extra boot light is installed.
Astra-J 2.0 CDTI S/S
Retrofitted AFL, TPMS, Navi950, BT, DAB, Rear Camera, Infinity sound system, Towbar, Flexfloor & more.
I can do programming and retrofits using genuine GM MDI and Dealer software.