fit reversing camera on astra j gtc

[Rusty2009]

Hi Rusty2009, I enabled feedback with cd600 vci code but when I switch from r to d the screen immediately goes black and the image disappears. I got the OEM Camera feed from the reversing light, where should I get the camera's energy for delayed camera switching. If you tell me your method, I would appreciate it, thank you.

It depends on which camera you have installed.

I am using an oem camera. which camera would you recommend to use for original connection

On the OEM camera there is a run crank wire this goes to the rear fuse board (you may need to swap out the rear board as some don't have the fuse or pin needed).
Of course if there is no rear fuse board then you run to the glove box fuse board and do a piggyback.

Rear fuse board X1 pin 33 (there maybe a wire in there in which case splice to it).
Glove box fuse board you can piggy back off fuse 21 & use a 2AMP fuse for the camera.

Please not the wire colours are for my own custom rear camera loom.
but follows to the following on the OEM camera
Pink = Red Run crank (Pin 6)
Blue = Yellow Camera signal +2 (Pin 1)
White = White Camera signal 2 (Pin 4)
Black Heat shrink = Black camera wire drain (Pin 2)
Orange = Green Reverse light (Pin 3)
Black = Black Ground. (Pin 5)