1:st-Feb-2015, 10:31:24
tucpal Wrote:the lumber support will just need power and ground
adding to the correct pins on the seat connection
and works from a button on the seat that bit is easy.
Drivers seat..
Position 10 positive to a piggy back fuse in position 16 glove box fuse box
Position 13 ground to you nearest grounding point Nut behind the glove box.
and if you have lumber support on both seats wire them up the same
and just join the wires to the wires you have just done for the drivers seat.
the heated seats are a different matter all together
and will all depend on what pins you have
in the connector under the seat.
Right got ya! Now this diea seem doable which is what I wanted to hear!
Regardless, I'll have a check in that connector and report back
Also thanks for the welcome! Seems like a great forum to be honest, lots of good how tos! Have already checked out the ambient light one