Flex ride retro-fit

[azajus]

Being working on this little retrofit for awhile now gathering the parts.

So I have the following parts.

Front shock's with springs, rear shocks, Front and rear sensors & the Flexride module.

I found it really hard to find the correct plug needed for the front strut extension harness, the only place that "stocked it" never had any stock and kept saying stock was coming in for months until I got shitty with them then they cancelled the order and refunded me.

I was able to finally find the plugs on ebay a little expensive as I had to buy the extension harness with them.

I did buy all the wire to make the loom myself but @Vocky had a loom which he sent me which meant I only needed to change the wire out to the engine bay.

The module both front and rear sensors are fitted & I've fitted the loom out to the engine bay so far.

I've made the 2 looms which run to the front sensors & my next looms to make is the 2 looms to the front shocks but I am awaiting some wire to arrive as I need to add the front wheel speed sensor wiring into them.

Then I plan on some ramp time to swap the shocks over.

Shocks and module


Flex ride main loom







Module fitted behind the Rear fuse-board





The 2 small looms for the front sensors made.



This retrofit also involves the fitment of EPB so here is the EPB loom made which has been fitted.

Hello Rusty,

Just a question - was it worth doing this retrofit? Is there a big diffrence between standard suspension and the flexi ride?