![[-]](https://vxoc.org.uk/forum/images/dark1.8/collapse.png "[-]")
25:th-Sep-2018, 11:37:57
Thanks for the reply, I've used the old adapter from original seat and only wired up the wires it had (very few), could do with some guidance on the remaining wires in terms of where to pin them, I've tried staying to the pin layout on page one but I have a couple of extra cables that I'm unsure what to do with, namely a small red one and an aditional BK/GY one which are not listed on the drivers side cable layout, so I'm unsure what they do or where to put them, however like I said I have all the pins car side so more than enough pins to accommodate, just don't know where to place them in the plug seat side.
https://prnt.sc/ky68fx
Ive been referencing this from another post too - https://www.vxoc.org.uk/Images/vxoc%20as...arness.jpg
Any guidance one what to do in regards to the mysterious two cables would be greatly appreciated! Excuse my temporary cabling I had ten mins before school run to get it up and running and wasn't sure how car would react to an unplugged drivers seat haha!
Cheers
https://prnt.sc/ky68fx
Ive been referencing this from another post too - https://www.vxoc.org.uk/Images/vxoc%20as...arness.jpg
Any guidance one what to do in regards to the mysterious two cables would be greatly appreciated! Excuse my temporary cabling I had ten mins before school run to get it up and running and wasn't sure how car would react to an unplugged drivers seat haha!
Cheers