![[-]](https://vxoc.org.uk/forum/images/dark1.8/collapse.png "[-]")
22:nd-Feb-2015, 09:56:14
Hi Mates,
your solder iron should not have more than 350°C, just give the led on the board some solder on both pins.
If done, just heat both pins at the same time with a little more solder so you can move it with the solder iron simply away.
After that just clean the pads.
For the rev counter it sounds like you put it too tight to the ground plate. Check the gap there, must be around 2-3mm.
your solder iron should not have more than 350°C, just give the led on the board some solder on both pins.
If done, just heat both pins at the same time with a little more solder so you can move it with the solder iron simply away.
After that just clean the pads.
For the rev counter it sounds like you put it too tight to the ground plate. Check the gap there, must be around 2-3mm.