Heated Seats Description and Operation

[tucpal]

Front Seat Cushion Cover and Pad Replacement

Removal Procedure
Warning:  Refer to SIR Warning .

Warning: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. The bladder, the pressure sensor, the seat cushion, and the control module are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly.
1.    Remove the driver or passenger seat. Refer to Driver or Passenger Seat Replacement .
2.    Remove the driver or passenger seat inner recliner finish cover. Refer to Driver or Passenger Seat Inner Recliner Finish Cover Replacement .
3.    Remove the front seat cushion side finish panel. Refer to Front Seat Cushion Side Finish Panel Replacement .



            2027608



4.    Detach the driver or passenger seat back cushion cover on the lower rearside of the backrest.
5.    Release and disconnect the backrest wiring harness plug (1), if equipped.
6.    Remove the 4 front seat backrest bolts (2).
7.    Remove the backrest from the seat.



            2027611



8.    Detach the driver or passenger seat cushion cover (1) from the seat frame (3) all way round.
9.    Remove the driver or passenger seat cushion cover along with the pad from the seat frame.
10.    Remove the driver or passenger seat cushion cover (1) from the pad (2), remove hogrings.
Installation Procedure



            2027611



1.    Install the driver or passenger seat cushion cover (1) to the pad (2), install hogrings.
2.    Install the driver or passenger seat cushion cover along with the pad to the seat frame (3).
3.    Attach the driver or passenger seat cushion cover (1) to seat frame (3) all way round.



            2027608



4.    Install the backrest to the driver or passenger seat.

Caution: Refer to Fastener Caution .

5.    Tighten the 4 driver or passenger seat back cushion frame bolts (2) to 35 N·m (26 lb ft) .
6.    Connect and latch the backrest wiring harness plug (1), if equipped.
7.    Attach the cushion cover to the backrest below.
8.    Attach the driver or passenger seat back cushion cover on the lower rearside of the backrest.
9.    Install the front seat cushion side finish panel. Refer to Front Seat Cushion Side Finish Panel Replacement .
10.    Install the driver or passenger seat inner recliner finish cover. Refer to Driver or Passenger Seat Inner Recliner Finish Cover Replacement .
Manuals Free virus removal Free car repair manuals Security System Injury Lawyers Instructions Injuries Start
New york injury attorney Starting Manuals Free virus removal Free car repair manuals Security System
Seats > Seat Hardware, Trim and Upholstery > Repair Instructions > Front Seat Cushion Cover and Pad Replacement