Hello,

I hope somebody has the pinout for the IPC and can upload it for me, for example i found this nice picture in the other thread about an other connector.

The engine code is A14NET if it matters, thank you.

<<<THIS IS A WORK IN PROGRESS, THREAD WILL BE INCOMPLETE  AND MAY CONTAIN INVALID INFORMATION UNTILL FURTHER NOTICE>>>

*pictures belong to various Russian users of Drive2, these will be updated with my own pics or other members the moment i attempt this myself*
*This tutorial is for a LEFT HAND DRIVE Astsra. (steering wheel on the left)

Howdy folks,

During these winter days, i notice my vehicle is very slow to warm up.
As it's a die

Hello i want to install a reverse camera tomorrow, but in the loom that is inside the left-hand side behind trim  there are two green/white wires, any suggestions? Thanks!!

Hi, does anyone know what terminals are in the X100 connector under the battery tray, (headlamp harness side male pins). I need to make some wiring to connect to the body loom to the PDC wiring I have so don't have to runs the wires to the boot. RS link to item if anyone has done this TIA.

Hi, does anybody know how the electric vacuum pump (for the brakes) is wired?

there are 2 wires (Red and Black) from the pump which go to a large connector block with 3 wires

what does the 3rd wire do?

I'd guess that red and black are live feed and earth, so is the "connector block" actually a relay and the third wire a trigger feed?

a wiring diagram may help if anyone has one.

the parts catalogue I've looked at shows the connector block coming with the pump assy

[img]https://i

Hi all, been browsing this forum for a little while and figured I'd try make use of the wealth of knowledge on here. So my problem is as follows I don't have the cable for the sun visor lights (I've taken entire headline off and still cant find it) so I purchased a complete headline loom with the suitable wires £20 so not too bad after taking apart most of the passenger side still wondering if theres a connector where the loom clips into or if have to splice connections to fit it (although on th

[align=center][size=small][img]https://www.vxoc.org.uk/Images/v

Hi. I need help. I want to retrofit front and rear PDC. I installed module, switch, rear wiring harness(bumper and loom to the module) and front bumper wiring. Now i need to make some custom loom, to connect front bumper harness to the car. I have connectors, i just need some wiring diagram, to know, where to connect wires. I know, that this loom connect under the battery to the other wirings, but anyone have some wiring diagram, to know where to connect which wire?
[attachment=1235]
[attachme

Hello all,

I am planning to fit/install front sequential LED light strip which has the function of DRL & indicator signals. I need help or advise on how best to do this. Is it best to try and tap into the side panel indicator or the lower front indicator that is next to the fog light? 

Any help would be appreciated, I have experience in wiring other lights on the car but this is the first time I have looked at fitting a sequential LED light strip that needs to use the indicators as a addit

Hi, can any one share the wiring diagram for the cd500 navi screen, I have retro fitted the cd500 in place of my cd400 and did the vin change via Abrites and it is working except for the screen, I have nothing on screen no back light or anything the stereo works fine now I can hear it and the buttons all work just no screen output. I would be grateful for any help anyone can spare. Thanks