(16:th-Dec-2016, 10:13:39)Rusty2009 Wrote: Electronic Parking Brake Control Module
Note: Verify the rear brakes are clear of any obstacles before starting the calibration procedure. During the procedure the rear brakes will cycle several times, stay clear of all moving parts until the process is complete.
Perform the Parking Brake Calibration procedure in Module Setup.
Calibration without Scan Tool
1.Ignition ON, apply and hold the brake pedal.
2.Push and hold the electric parking brake switch down for 5-6 seconds.
3.Release the electric parking brake switch.
4.Momentarily push the electric parking brake switch down.
5.Remove the EPB MODULE fuse and reinstall. (Engine fuse-board fuse 29 30A K83 Parking Brake Control Module (J71))
6.Apply the electric parking brake.
7.Release the electric parking brake
If this fails please as I stated before get the fault codes read and let us know what they are.
Been busy for couple of days.
I did try what you told me but no luck. I took it back to mechanic and the fault is the Electric parking brake module. I rang Vauxhall to find out and they quoted £650 including VAT!
Any idea if I can get this part cheaper because £650 is ridiculous.