Rear wiper removal

[Dannydyer]

Hi guys!

I know not everyone likes this mod but has anyone removed their rear wiper and is it easy to do?

Thanks

[tucpal]

someone did it recently in their progress thread can not remember who it was

[Shorty S91]

Its easy enough to do mate. Remove the wiper arm from the exterior using a 13mm socket or spanner and then wiggle it free from te motor spindle. On the interior there is a T20 torque screw holding the rear trim panel onto the boot lid so you will want to remove this first. Once the screws out the panel can be pulled off, just be careful not to pull to hard otherwise you risk cracking the plastic. Once thats off and out the way all you need to do is remove the connector from the motor and tape it up securely. Then remove three bolts that hold the motor in place (cant remember what size) and then you can pull it out from the lid and window. Then just pop in a grommet to cover the hole, again I cant remember the size of it but there pennies to buy and you usually get a few in a pack.

[J1ODYA]

Where do you buy these grommet?

Sent from my SM-G920F using Tapatalk

[Jj0063]

You can now get glass grommets which are completely flush and look perfect..

https://www.gecleant.de/shop/glasstopfen...l?page=all

Just need to find them UK based, just measure what size you need & google it!

[bhalay207]

That looks alot better than an unsightly rubber bung

Sent from my LG G4 using Tapatalk

[Shorty S91]

That looks alot better than an unsightly rubber bung

Sent from my LG G4 using Tapatalk

i'm gonna get rid of the rubber grommet for this purpose. Plus sometimes ill come back to the car and someones pushed it in.

[J1ODYA]

That looks alot better than an unsightly rubber bung

Sent from my LG G4 using Tapatalk

i'm gonna get rid of the rubber grommet for this purpose. Plus sometimes ill come back to the car and someones pushed it in.

lol who would do that?

How much are these & what size we need?

Sent from my SM-G920F using Tapatalk

[Shorty S91]

Thats the grommet i bought for my old car and its the one thats in my gtc not sure on the size though

[Dannydyer]

I know "kill all wipers" are making one for astras at the moment but not gonna wait! May just use a rubber one for now? Isnt it a 32mm?

[Shorty S91]

Just went out and took some measurements there and its coming in at 26mm. I checked the size of the grommet I fitted and its 25mm. the 25mm fits but i can pull it out with little resistance. Gonna see if i can find a 26mm glass grommet cheap and try it. worst case scenario if it is a tight fit ill sand round the edges to get it snug.

---

Ive just ordered one so ill let you know how it goes. Some places are charging upwards of 20 quid for these just for the glass. the one ive bought has the adhesive and its still relatively cheap at £10

[Dannydyer]

Okay yeah let me know! I have 100's of 25mm at work shame really

[Shorty S91]

Okay yeah let me know! I have 100's of 25mm at work shame really

as I said im using a 25mm grommet just now and it keeps the rain out. I would just prefer it to be a bit tighter 

[Dannydyer]

Might use a 25mm for now as a temporary fix

[Dannydyer]

Okay yeah let me know! I have 100's of 25mm at work shame really

as I said im using a 25mm grommet just now and it keeps the rain out. I would just prefer it to be a bit tighter 

Did you use anything to seal it?

[Shorty S91]

Nah just popped it in there haha!

The glass grommet arrived today so it has been fitted



This is a 25mm grommet. I went out and measured again a few times. Just thought that 26mm would have been to tight and would have needed sanding around the edges.





This came with a little bag of black sealant. I just covered the entire grommet in sealant and popped it in and held it in place for a few minutes. Afterwards I got some silicone spray and covered the outside with it and rubbed my fingers around the outside of the grommet so there is a nice smooth seal, just wipe away any excess sealant and apply silicone spray to help create a good smooth seal.

This is the link for the grommet.
http://www.ebay.co.uk/itm/291617168791?_...EBIDX%3AIT

[J1ODYA]

Looks good... I too spoke to kill my wiper and they are only a week or 2 away from having a flush kit so shall wait.

Sent from my SM-G920F using Tapatalk

[Shorty S91]

this one sits flush, this was it just after I fitted. I went back out after 5 minutes and ran a card over the area so that it pushes in slightly so that its all smooth

[Dannydyer]

Looks good !

[J1ODYA]

It does look good

Sent from my SM-G920F using Tapatalk

[sheppy1]

I like the look of it! But what happens when the rear screen gets filthy? Just gonna have to keep wiping it before you get in?

Sent from my XT1092 using Tapatalk

[mrtc]

unless your going all in smooothing over the whole car, handles badges, etc etc i think its a backwards mod, ive owned cars that didnt have rear wipers as they didnt come standard, its a right faff

[bhalay207]

I remember a saloon I used to have, the rear window had no wiper and it end a nightmare

Sent from my LG G4 using Tapatalk

[sheppy1]

Balls to it then... Not gonna do it myself

Sent from my XT1092 using Tapatalk

[J1ODYA]

Oh the rear wiper is crap on the gtc and at £30 a piece to replace I'd rather a dirty window!

And my car never gets that dirty anyway.

Sent from my SM-G920F using Tapatalk

[bhalay207]

Oh the rear wiper is crap on the gtc and at £30 a piece to replace I'd rather a dirty window!

And my car never gets that dirty anyway.

Sent from my SM-G920F using Tapatalk

Not sure where you got £30 from mate

Sent from my LG G4 using Tapatalk

[J1ODYA]

Genuine Vauxhall ones... you can get them for £6 off ebay but they are crap.

Sent from my SM-G920F using Tapatalk

[Shorty S91]

I tend to use my mirrors more than i do look out of the rear window, cars cleaned at least once a week anyway and its constantly raining in scotland anyway, so its never bothered me .

[Tonto]

I'm contemplating doing this too but living in Newcastle it mainly rains and rear screen gets dirty quickly!


Sent from my iPhone using Tapatalk

[Kris]

Guys I'm doing this now. Just done the 3 10mm bolts and how the hell do you separate the wiper from the motor lol?

[Tonto]

It's stiff but it does just pull apart. If you try twisting the wiper to loosen it a little.


Sent from my iPhone using Tapatalk

[J1ODYA]

Wiggle it...

Sent from my SM-G920F using Tapatalk

[stigeye]

Don't undo the bolts, remove the wiper blade before you undo the bolts. I put some grips on the metal body attached to the bolt on the outside and twisted/ wiggled it a little and it just popped off.

[Kris]

My bad lads, i forgot to take the plastic bit off to reveal the nut before attempting to loosen it lol!! All done now though and looks much better. cheers.

[stigeye]

My bad lads, i forgot to take the plastic bit off to reveal the nut before attempting to loosen it lol!! All done now though and looks much better. cheers.

I saw your post last night on Facebook saying you forgot to undo the wiper blade bolt, have to say I did chuckle... rather loudly  

May as well put up a picture of my effort on this thread...

[Tonto]

My bad lads, i forgot to take the plastic bit off to reveal the nut before attempting to loosen it lol!! All done now though and looks much better. cheers.

I saw your post last night on Facebook saying you forgot to undo the wiper blade bolt, have to say I did chuckle... rather loudly  

May as well put up a picture of my effort on this thread...

Me too


Sent from my iPhone using Tapatalk

[J1ODYA]

lol doh

Sent from my SM-G920F using Tapatalk