Wheel painting

[Rusty2009]

found this



Very clever.

Site HG Arts - Water Transfer Printing - Hydrographics

[J1ODYA]

As seen on Wheeler Dealers when he did the Range Rover interior parts.

[Rusty2009]

I don't remember seeing it on wheeler dealers mate, mind you I notice the run a new series and cut it off after a couple of shows.

[cornishtaz]

Wheeler dealers also did some wheels and spoiler of a RX7 recently

Sent from my GT-I9505 using Tapatalk

[tucpal]

i had some dipped interior trim bits on the mark 5 and they do look very good
you can actually buy the bits to do this your self but you are best to clear coat when done
i would love a few bits done on the j i may look into this for the alloys :cool

[tucpal]

here you go rusty Black Carbon Fibre Hydrographics Film - Rolled In Tube - Dip This | eBay

and the activator http://www.ebay.co.uk/itm/Hydrographics-...4ad3c1c92e

so much more fun and a better result than wrapping
and there are loads of designs to choose

[cornishtaz]

Might get the plastics under my bonnet done blue carbon fibre effect

Sent from my GT-I9505 using Tapatalk

[tucpal]

here is how to do it

DIY camo gun dipping kit hydrographics - YouTube

but you really only need the film and the activator as long as the part is clean before you dip you can use primer for a better result
and clear coat after is a must for protection and new water must be used for each part you dip

My girl friend dipping my bits using mydipkit from http://www.mydipkit.co.uk.mp4 - YouTube

[JohnL]

Seen some video's of that stuff the other day. Does look very easy to do. And not as expensive as I 1st thought.

[Simon Templar]

Good video Rusty , a joy to watch. I wonder if they do carbon black. .

[Cameron UK]

Yeh I've seen it done in carbon black before, wonder how long it would last in the elements

[tucpal]

you have to use clear coat lacquer over it and it will last
but very hard to fix if you curb the alloys.
interior parts last very well