AFL / Xenon retrofit - Printable Version +- VXOC Astra-J/GTC (https://vxoc.org.uk/forum) +-- Forum: Astra-J/GTC Section (https://vxoc.org.uk/forum/forumdisplay.php?fid=5) +--- Forum: Retrofit Research (https://vxoc.org.uk/forum/forumdisplay.php?fid=23) +--- Thread: AFL / Xenon retrofit (/showthread.php?tid=114) |
AFL / Xenon retrofit - Rusty2009 - 27:th-Oct-2014 Jonika21 Wrote:finally ! congrats rusty ! I won't be doing a how-to for this one sorry mate it's cost me a lot of money and time and is very complicated plus you need a VCI code. JohnL Wrote:Well done Rusty! Bet you are looking forward to taking the car for a spin in the dark now Yes mate I need to put some charge in the battery and also get some fuel as I'm below quarter of a tank and I don't like being that low. AFL / Xenon retrofit - cornishtaz - 27:th-Oct-2014 Well done mate you won't be disappointed. I think a how-to needs to be done as there's a lot of interest in the retrofit and I think the price will come down AFL / Xenon retrofit - Jonika21 - 27:th-Oct-2014 cornishtaz Wrote:Well done mate you won't be disappointed. +1 Sent from my iPhone using Tapatalk AFL / Xenon retrofit - tucpal - 27:th-Oct-2014 well done rusty that has been a major amount of dedication and work to have gone through with this it was a pleasure to help in proving that ALF can be done at long last WELL DONE.... unfortunately it is a bit like the NAV retro fit programming is a big part of this and this is something the dealers will not do. i am sure if you want this done rusty can sort a price out to fit and program but it will not be cheep as the parts are expensive and there is a fair amount of work involved and not every car will be able to do this. AFL / Xenon retrofit - tucpal - 27:th-Oct-2014 we want a day and knight vid AFL / Xenon retrofit - Rusty2009 - 27:th-Oct-2014 tucpal Wrote:we want a day and knight vid Yeah once I've put the car back together AFL / Xenon retrofit - Rusty2009 - 27:th-Oct-2014 Well what I will do is add some info so people can check there fuse board if you have the wrong board its a non starter unless you pay the £350+ for a new board. AFL / Xenon retrofit - Jonika21 - 27:th-Oct-2014 Thanks rusty. Sent from my iPhone using Tapatalk AFL / Xenon retrofit - Cameron UK - 27:th-Oct-2014 Now u need to get the washer jets working otherwise it's an mot failure, good work though! AFL / Xenon retrofit - Rusty2009 - 27:th-Oct-2014 Yep just waiting on GM to get back to me on that as I've tried SPS'ing the IPC as that's where they are turned by and it wont hold the info, I asked them If I need a VCI and they said no so I've asked them how I turn them on as the SPS'ing the IPC wont turn hold the software to turn them on. AFL / Xenon retrofit - cornishtaz - 27:th-Oct-2014 Here's something interesting to ponder over the Corsa comes with AFL's but dosent have headlight washers and has manual headlight leveling. AFL / Xenon retrofit - JohnL - 27:th-Oct-2014 cornishtaz Wrote:Here's something interesting to ponder over the Corsa comes with AFL's but dosent have headlight washers and has manual headlight leveling.The Corsa doesn't have xenon's does it? AFL / Xenon retrofit - Rusty2009 - 27:th-Oct-2014 You can manual on the Astra if you wanted. AFL / Xenon retrofit - Migwell030744 - 27:th-Oct-2014 Congratulations Rusty, I always knew it, that you would be successfull in the end. Good work, now put your feet up for a while you deserve the rest. And so does your bank balance. Regards Migwell AFL / Xenon retrofit - cornishtaz - 27:th-Oct-2014 Yep Corsa definitely has Xenon's AFL / Xenon retrofit - Rusty2009 - 27:th-Oct-2014 Well been for a drive and I'm so glad it's fitted and working now, I could see where I was going went round a corner and the lights followed lol. Glad I kept at it I was getting close to giving up. Sent from my iPhone 5c using Tapatalk. AFL / Xenon retrofit - Migwell030744 - 27:th-Oct-2014 So pleased its all good Sent from my iPhone using Tapatalk AFL / Xenon retrofit - Turner_SRi - 27:th-Oct-2014 I need these in my life lol Sent from my Samsung Galaxy S5 SM-G900F using Tapatalk. AFL / Xenon retrofit - Kevin - 27:th-Oct-2014 Cameron UK Wrote:Now u need to get the washer jets working otherwise it's an mot failure, good work though! They only need to work if it looks like they are fitted. If in doubt, then it's a pass AFL / Xenon retrofit - Rusty2009 - 27:th-Oct-2014 Kevin Wrote:They only need to work if it looks like they are fitted. If in doubt, then it's a pass That was my thoughts on it. Sent from my iPhone 5c using Tapatalk. AFL / Xenon retrofit - Rusty2009 - 28:th-Oct-2014 Right been a bit of a back and forth day today. GM sent me the VCI code for the IPC which I put in this, this wiped out my TPMS so I then got 2 new VCI codes one for the BCM which included the the TPMS, headlamp washers and AFL and one for the IPC which included TMPS & AFL. So headlamp washers do work via GDS2 but not the stalk I'm going to have to check the wiring to make sure although I know it's all there at the BCM. AFL / Xenon retrofit - tucpal - 28:th-Oct-2014 there will be a data signal some were you are getting there AFL / Xenon retrofit - Rusty2009 - 29:th-Oct-2014 Headlamp wash AFL / Xenon retrofit - JohnL - 29:th-Oct-2014 So does that mean you've got it all sorted now? AFL / Xenon retrofit - Rusty2009 - 29:th-Oct-2014 That's controlling it via GDS2 which I could never do before, stalk still need to look into it. Which I will do but not today. Got to make my daughter a headboard today. AFL / Xenon retrofit - tucpal - 29:th-Oct-2014 getting there :cool but were is my ALF night video AFL / Xenon retrofit - Rusty2009 - 29:th-Oct-2014 tucpal Wrote:getting there :cool Your have to wait my dash cam comes and I've fitted it AFL / Xenon retrofit - tucpal - 29:th-Oct-2014 that will do but go for a nice drive down a twisty lane so we can see the corner lamps work :cool AFL / Xenon retrofit - JohnL - 29:th-Oct-2014 That reminds me I refitted the dash cam AFL / Xenon retrofit - Rusty2009 - 29:th-Oct-2014 Right for those that want to check the fuse board.
Please note these are pictures of a donor board. Fuse's and relays 12 Adaptive forward lighting module 23 Headlamp washer system 24 Right low beam (Xenon) 25 Left low beam (Xenon) 33 Adaptive forward lighting K05 KR2 HeadlampWasher Fluid Pump Relay K06 KR49 Headlamp Low Beam Relay You can check where all these are in the fuse's thread http://www.vxoc.org.uk/forum/Thread-Fuses 2nd post If you have them it would be safe to say you have all pins underneath but it will pay to double check this. So Disconnect the Negative terminal of the battery, then undo the 3 10mm bolts (they wont come out) you will feel a slight click when they are undone. DO NOT REMOVE ANY FUSES OR RELAYS YOU DON'T NEED TO Next get a trim tool and if you look on each side of the board you will see 2 clips just use the the tool and praise them outwards and lift one Conner of the board at a time (Not too far just enough so they are un-clipped) Then carefully lift the board up may need a wiggle and then turn it over and just make sure the bottom of the board has all pins in (in this picture you can see some are missing). Refit the board Make sure you do not over tighten the blots but make sure they are done up nice and tight If your car wont start afterwards you've not tightened them up enough. PLEASE ASK ALL QUESTION IN THIS THREAD AS PM'S WILL BE IGNORED (LET OTHERS KNOW THE ANSWER/S TO ANY QUESTION/S TOO) AFL / Xenon retrofit - Jacket2122 - 30:th-Oct-2014 Looking good, hats of to you! AFL / Xenon retrofit - Rusty2009 - 30:th-Oct-2014 JohnL Wrote:That reminds me I refitted the dash cam Got some Pic's mate AFL / Xenon retrofit - JohnL - 30:th-Oct-2014 Will get them tonight and stick them up. Need to finish running the wire to the power point as currently comes out under the glove box and along the side. The camera isn't as small as the one you've order though AFL / Xenon retrofit - Rusty2009 - 30:th-Oct-2014 tucpal Wrote:that will do but go for a nice drive down a twisty lane so we can see the corner lamps work :cool Looks like someone is going out tonight for a drive AFL / Xenon retrofit - z8083 - 31:st-Oct-2014 Rusty well done enjoy your new headlights . May i ask you something i have all the fuses and relays on the fuse box can afl be retrofiteed in my car ? also dash cam for high bean assist is needed or it can work without it. AFL / Xenon retrofit - Rusty2009 - 31:st-Oct-2014 If you have all the fuses relays I see no reason why not, have you pulled the board out and checked you have a full set of PIN's? I fitted the HBA mirror and I've turned it on via the IPC but tested it last night and couldn't get it working, It's not needed and it's not listed as part of the AFL system. I could check your part number of the fuse board. If you can get me the part number and Ident code I've put a red mark around in the below pic. It must be said that AFL is not a recognized retro-fit and therefore to request the VCI code's I had to select another retrofit option and GM could still refuse to supply the VCI code's. AFL / Xenon retrofit - z8083 - 31:st-Oct-2014 Part number 13302311 qc , i have all fuses and relays in potition weird ,and 2010 models needs vci? thanks rusty. AFL / Xenon retrofit - Rusty2009 - 31:st-Oct-2014 Odd that part number cannot be found in my March 2013 copy of EPC I'm going online tomorrow so I will check it tomorrow. My understanding is that pre 2012 cars don't need VCI codes for the radio side of things but does for other things, I've got to request a VCI code for retrofitting front fogs to a 60 plate tomorrow. AFL / Xenon retrofit - Rusty2009 - 31:st-Oct-2014
This should show the lights twisting as I go round the roundabouts
I know you wanted county lane @tucpal but we were moving slow on it and unless I go miles out there aren't to many near me. AFL / Xenon retrofit - Rusty2009 - 1:st-Nov-2014 z8083 Wrote:Part number 13302311 qc , i have all fuses and relays in potition weird ,and 2010 models needs vci? thanks rusty. I checked that part number online and still won't find it so it must of been replaced with a new part number but it normally locates it. I'll contact the dealership Monday and see what they find. Sent from my iPhone 5c using Tapatalk. AFL / Xenon retrofit - cornishtaz - 1:st-Nov-2014 I found a 2nd hand fusebox with the same part number on ebay and the listing had a VIn so put that into EPC and came back with the following part number 13302305 AFL / Xenon retrofit - Rusty2009 - 1:st-Nov-2014 Thanks BAZ, didn't think to look on eBay. Sent from my iPhone 5c using Tapatalk. AFL / Xenon retrofit - z8083 - 1:st-Nov-2014 I find it on ebay with same part number but nothing more , also in oemcats i find it with same part number and it says Opel\Vauxhall kat-code: 1247020 i don't know if that helps . Thank you guys . AFL / Xenon retrofit - Rusty2009 - 2:nd-Nov-2014 Yes I found the Kat number and still nothing, The part number Baz posted doesn't list T4A (Halogen) or T4F (Xenon) so should be capable of running both. I still advise you check the pins on the bottom of the board though. AFL / Xenon retrofit - Rusty2009 - 2:nd-Nov-2014 Baz can you confirm there are fact 2 ballasts for the 3 door AFL headlamp? One on the bottom and one on the side. AFL / Xenon retrofit - cornishtaz - 2:nd-Nov-2014 Yes there are 2 one is for the bulb think the other is for lense movement AFL / Xenon retrofit - Rusty2009 - 2:nd-Nov-2014 Thanks mate just wanted to confirm as EPC list two, crazy there is two on GTC and one on the the 5 door. AFL / Xenon retrofit - Rusty2009 - 8:th-Dec-2014 After seeing @Dicko yesterday and chatting about the headlamp washers I can confirm mine are working 100%, mind you doesn't seem to clean them much but with all that salt on the roads yesterday it's no wonder AFL / Xenon retrofit - sotoskon - 3:rd-Feb-2015 cool... AFL / Xenon retrofit - semxoz - 18:th-Feb-2015 Rusty Hi Please HELP ME, Could you write me a catalog numbers connectors are inserted into the module AFL |