26:th-Nov-2017, 12:47:43
If you are a dab hand with a needle might get a better result. It wasn't terrible or anything, just not that factory tight fit.
Regarding the switches, these are tactile PCB switches so it would run off the one-wire comms would it not? Might look at my PCB again as I can't help but think the board switches were there so it may be as simple as doing a switch test and checking the pin-out from the bcm for a signal.
||Sent based on the twin scientific principles of star maths and wishy thinking.||
Regarding the switches, these are tactile PCB switches so it would run off the one-wire comms would it not? Might look at my PCB again as I can't help but think the board switches were there so it may be as simple as doing a switch test and checking the pin-out from the bcm for a signal.
||Sent based on the twin scientific principles of star maths and wishy thinking.||