This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Welcome back to the VXOC FORUM. Sorry for our lack of support over the last year but MYBB is back and so are we. Let's get the forum buzzing again... (March 25, 2022) x



Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

[-]
Tags
lightboard

Lightboard
#1
Possibly a one for tucpal or rusty2009. I have just connected a 7 pin socket to connect a lightboard for my bike carrier. when connected and brake pressed the brake flickers on the light board then goes off. The normal brake lights stay on but I get a message on the dash to check brake bulbs. Could this be because it is detecting too much load?

Sent from my SM-G900F using Tapatalk
Reply
#2
I would think so try adding a load to the brake light one each side hopefully that will work for you
[Image: DSC03659_zpssmtodvyc.jpg]
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)

Switch to mobile version