+- VXOC Astra-J/GTC (https://vxoc.org.uk/forum)
+-- Forum: Astra-J/GTC Section (https://vxoc.org.uk/forum/forumdisplay.php?fid=5)
+--- Forum: ICE (https://vxoc.org.uk/forum/forumdisplay.php?fid=95)
+--- Thread: Couple of things after installing B5754 (/showthread.php?tid=3656)
Couple of things after installing B5754 - jw021979 - 28:th-Nov-2017
I have just installed a B5754 that I got from Icebox. Seemed to go ok except I can't get the radio control panel working. I have connected all the cables. The heater control and traction control button works OK. Steering wheel controls work OK
The only other strange thing is the Eco button lights up but is flickering.
RE: Couple of things after installing B5754 - sparkyscfc74 - 28:th-Nov-2017
(28:th-Nov-2017, 18:42:28)jw021979 Wrote: I have just installed a B5754 that I got from Icebox. Seemed to go ok except I can't get the radio control panel working. I have connected all the cables. The heater control and traction control button works OK. Steering wheel controls work OK
The only other strange thing is the Eco button lights up but is flickering.
Hi, I'd just check that you haven't trapped any wires when installing because I had a mare trying to fit everything behind the dvd drive and it can sometimes pull the wires that go to the control panel.
RE: Couple of things after installing B5754 - jw021979 - 28:th-Nov-2017
I will go through all the cables again and make sure everything is plugged in OK. Found a couple of other things now after going out for a drive.
When putting the car in reverse it goes into reverse camera mode muting the music/ radio. This is annoying as I havent got a reverse camera fitted so I just get a warning triangle on the screen.
I opened a pre-installed app called AJX I think it said. This opened up what looks like a dialling screen and say OnStar. This app doesnt appear to anything so I backed out but it won't close. All I have on my screen now is a dialling screen. which won't close. Looks like my drive to work in the morning is going to be in silence.
Couple of things after installing B5754 - sparkyscfc74 - 28:th-Nov-2017
Right, I haven’t got that pre installed app so I don’t know what it is or does. When you turn your ignition off and open the door, the unit should power off. When you turn it back on, is it still stuck in the app? If that sorts it, then regarding the reverse volume/ blank screen, you’re right it will always be blank until you fit a camera mine cost a tenner and was fitted within an hour. If you don’t want the music to mute in reverse, then go into the options menu and scroll down to “car”
![[Image: 7f57593cba4d830c30be2cde10177eeb.jpg]](https://uploads.tapatalk-cdn.com/20171128/7f57593cba4d830c30be2cde10177eeb.jpg)
Then select the reverse volume and either select “on” or set it to go quieter from -1 to -10
![[Image: 843a84c77d464a0b87e6aeeef29ed607.jpg]](https://uploads.tapatalk-cdn.com/20171128/843a84c77d464a0b87e6aeeef29ed607.jpg)
Hope this helps?
Sent from my iPhone using Tapatalk
RE: Couple of things after installing B5754 - jw021979 - 28:th-Nov-2017
I get it to shutdown but it came back up with the app again. Hopefully leaving it overnight might fix it.
Couple of things after installing B5754 - sparkyscfc74 - 28:th-Nov-2017
Have you got a picture of the screen with the app on?
Sent from my iPhone using Tapatalk
RE: Couple of things after installing B5754 - jw021979 - 28:th-Nov-2017
What ever button pressed it does nothing.
Couple of things after installing B5754 - sparkyscfc74 - 28:th-Nov-2017
Will it let you scroll the top menu down? If so you can access the settings menu and do a factory reset? If not you may have to strip the facia off and pull the main plug out of the back of the unit?
Sent from my iPhone using Tapatalk
RE: Couple of things after installing B5754 - jw021979 - 28:th-Nov-2017
Top menu will pull down but that app always stays on top so you can't see any other app. Looks like my nice new headunit is coming out tomorrow.
RE: Couple of things after installing B5754 - jw021979 - 29:th-Nov-2017
Managed to remotely reset it as I had already logged in using my Google account. The app causing my problem is no longer installed. I suspect my unit had been used before as I also noticed before the app problem that the Bluetooth had already been paired with something before I got it.
Couple of things after installing B5754 - sparkyscfc74 - 29:th-Nov-2017
That’s not good, I’d have a word with Rob at Icebox about that, you’re supposed to be buying a new item not Manufactuer refurbished or even second hand. Glad you got it sorted though, I’ve had no issues with mine and think they’re well worth the money
Sent from my iPhone using Tapatalk
RE: Couple of things after installing B5754 - jw021979 - 1:st-Dec-2017
Any ideas on getting the radio control panel working?
I have tried to connect the connector on the right of the above picture to the connector that was plugged into the right, half way up the contol panel and that didn't work.
Couple of things after installing B5754 - sparkyscfc74 - 1:st-Dec-2017
The small connector on the right, plugs into the unused plug from your old display
Sent from my iPhone using Tapatalk
When you took out your old display there were 2 connectors to it and you only need one in your new display, the other plugs into that small connector
Sent from my iPhone using Tapatalk
RE: Couple of things after installing B5754 - jw021979 - 1:st-Dec-2017
That ma explain why it doesn't work. Doh!
Couple of things after installing B5754 - sparkyscfc74 - 1:st-Dec-2017
Yeah that should sort it, when you’ve sorted it everything should do as it did apart from the info button will start the sat nav
Sent from my iPhone using Tapatalk
RE: Couple of things after installing B5754 - jw021979 - 1:st-Dec-2017
Got it working. Thanks for that. I knew it would be something daft like that. I do have a couple more questions, sorry to be a pain.
The heater display shows 2 temperatures. The one on the left goes up and down with the temperature dial but I can't figure out what the one on the right is all about (it normally says about 17 degrees).
I use Torque Pro on my phone with a Bluetooth OBDII reader. The B5754 won't connect to my OBDII reader, it sees it but when i click pair it doesn't do anything. Any idea about a OBDII reader that will connect OK.
Couple of things after installing B5754 - sparkyscfc74 - 1:st-Dec-2017
No problem, the other temperature is for dual zone climate control so if like me you haven’t got it then ignore it! With the OBD2 reader I can’t remember what I did exactly. When you go into your Bluetooth app and press the search icon, does it show up there?
![[Image: be9c10fbe1913cbd699a247f4c4eb7f9.jpg]](https://uploads.tapatalk-cdn.com/20171201/be9c10fbe1913cbd699a247f4c4eb7f9.jpg)
Sent from my iPhone using Tapatalk
RE: Couple of things after installing B5754 - jw021979 - 1:st-Dec-2017
I was pairing it from the settings menu. I will give the bluetooth app a try
Couple of things after installing B5754 - sparkyscfc74 - 1:st-Dec-2017
I’m sure that’s what I did
Sent from my iPhone using Tapatalk
Couple of things after installing B5754 - sparkyscfc74 - 2:nd-Dec-2017
Have you managed to get it connected yet?
Sent from my iPhone using Tapatalk
RE: Couple of things after installing B5754 - jw021979 - 2:nd-Dec-2017
Yep, cheers. So far everything seems to be working as they should. Received DAB module today, see how that install goes.
Couple of things after installing B5754 - sparkyscfc74 - 2:nd-Dec-2017
Yeah let me know, mine’s a goddamn Christmas present
Sent from my iPhone using Tapatalk
Couple of things after installing B5754 - sparkyscfc74 - 3:rd-Jan-2018
How are you finding your dab unit? Mine is pants!!! It keeps making the head unit freeze and seems to be some conflict with the front dvr cam???
Sent from my iPhone using Tapatalk
RE: Couple of things after installing B5754 - jw021979 - 4:th-Jan-2018
I havent got it properly installed yet. Tried it with antenna not properly installed and so far found the reception rubbish. I'm not using a front dvr cam.
Couple of things after installing B5754 - sparkyscfc74 - 4:th-Jan-2018
I’m not convinced they’re any good tbh
Sent from my iPhone using Tapatalk
RE: Couple of things after installing B5754 - jw021979 - 6:th-Jan-2018
I got my DAB installed today. Reception where I am is not amazing. Will have to see how it is when out and about.
Couple of things after installing B5754 - sparkyscfc74 - 6:th-Jan-2018
Mine was fine at home but as soon as I drove around if the signal drops it goes off then the whole head unit freezes!!! Don’t know what to do next.
Sent from my iPhone using Tapatalk
RE: Couple of things after installing B5754 - stigeye - 10:th-Jan-2018
Poor dab reception is the major reason why I wont get one of these units. I have no issues with factory dab and it would drive me insane if dab reception was poor on the android units even if they are great with everything else.
RE: Couple of things after installing B5754 - mephisto - 3:rd-Jul-2019
(1:st-Dec-2017, 17:54:22)sparkyscfc74 Wrote: The small connector on the right, plugs into the unused plug from your old display
Sent from my iPhone using Tapatalk
When you took out your old display there were 2 connectors to it and you only need one in your new display, the other plugs into that small connector
Sent from my iPhone using Tapatalk
Would you mind to tell me a bit more about this connector and cable? I'm struggling to find a way to get my cd400 buttons to work