Op-com turbo boost control learn - Printable Version +- VXOC Astra-J/GTC (https://vxoc.org.uk/forum) +-- Forum: Astra-J/GTC Section (https://vxoc.org.uk/forum/forumdisplay.php?fid=5) +--- Forum: Astra-J/GTC Howto's (https://vxoc.org.uk/forum/forumdisplay.php?fid=21) +--- Thread: Op-com turbo boost control learn (/showthread.php?tid=3387) |
Op-com turbo boost control learn - kyle-astra-j - 22:nd-Jun-2017 I have a fault code that comes up turbo boost not learned any one had this issue cheers astra j 2.0 cdti tried to learn it on op-com but don't no if I am doing it right Sent from my SM-G930F using Tapatalk RE: Op-com turbo boost control learn - Rusty2009 - 29:th-Jun-2017 As said MDI only job RE: Op-com turbo boost control learn - gazz292 - 2:nd-Feb-2018 I know this is an old-ish thread... and this may not be relevent, my cars a meriva 1.3 cdti (A13DTE engine) i was getting the following fault codes recuring: P0299 - Engine Underboost P003A - Turbocharger Boost Control Position Not Learned Also had an overboost one once, and car went into limp home mode a few times, always coming back with the P003A code. Checked the turbo's variable vane lever, and it was stuck, i worked it up and down a few times (had to use a screwdriver to lever i first few times) then it free'd off and i could then move it by sucking on the vacuum pipe (poor mans mitty vac I'd read that the car will do a boost control position calibration once per engine start, certain conditions like over a certain cooland temp and that, but after freeing my vanes off, the DTC went away and hasnt come back, Ok i then got : P2453 - Diesel Particulate Filter (DPF) Differential Pressure Sensor Circuit - High Temperature This was the DPF pressure sample pipe spit, common thing aparantly, rubber hose off the short metal pipe on the DPF... was bound to go at some point, replaced with with some 8mm fuel pipe and been fine since. |