21:st-Feb-2014, 20:02:13
this is for the NAV500 and 600 that have the FM already in Place
And the Shark Fin on the Roof for the Sat Nav
But do not Have DAB.
If you have the CD400 go to the CD400 DAB how to.
So if you have the NAV500 or 600
And you have the Tabs in Place on the Rear window
then you will find the one for the DAB is a Dummy
just put there in Place to make it Look nice.
Remove the Trim from the Tail Gate
you will see all the Receivers are There for the FM
So you only need the DAB Receiver (ZA)
And a 1 Meter fakra Z Cable
Going from the Receiver (ZA) to the Double Female Connector
In the Roof Right hand side just under the Headliner
just follow the Cable from the Shark fin to find the Connector you need
it will have one coming from the Shark fin for SAT NAV
and an Empty Slot that you need for the DAB.
Thread the Fakra Z Cable 1 Meter Female too Male
From the Receiver Through the Tail Gate
to the Right hand side off the Headliner.
See the Blue Plastic on the End of the Male Connector Pictured above
you now have to Remove the Blue Plastic Case and just Leave to Metal Pin
so Gently cut the Blue bit away Leaving the Metal Pin inside and in tacked
it is the Metal Pin that will Connect to the Double Female end in the Roof
i do not have a Picture of the Connector Striped or of the one in the Roof
so if any one can send me one it would help others.
You now need to get the DAB Module and Connect it up to the Exiting
Connectors in the front Foot Well just above the Accelerator Peddle
you are looking for the Black and Green Connectors there.
The Module is held in Place by a Bracket
That you must also get and one Screw
once you have that all in Place
you are now Ready for Programming and VCI Activation
You will have DAB Radio
DAB Module Part Numbers are
for the (Astra J 13319590 UBT)
and for the (Astra J GTC 13362385 UBT.)
the Cradle for the DAB unit is (GM 13263525).
AS WITH ALL ELECTRICAL HOW TOO,S.
you do this at your own risk if you follow the how to correctly
there should be no problems thank you.